Beurer PM 90 Gebrauchsanleitung Seite 35

Once you are in the menu
monitor automatically switches to the main dis-
play. This displays the already recorded training
time on the middle line (after Save/Delete:
00:00:00) and on the line below
By pressing the
the information in the bottom line.
Things to know about the recordings
As soon as you have started the recording, your HR monitor

starts recording your training data. Your HR monitor continually
records your training data until you save or delete this. This also
applies when you first start training on the following day. The run-
ning time also allows you to stop your training session at any
time.
If "0" is displayed for a longer period on the display, this means

that the receipt of the signals has been interrupted. In this case
change into the
The HR monitor tries to make contact with the devices once more.
Your HR watch has a memory. You can record up to 23:59:59

hours in each training session. Depending on the sampling rate,
you can record training periods ranging from 2.8 hours (with a
5 sec interval) to 67 hours (with a 120 sec interval). Once
23:59:59 hours is reached, you must either save or delete the
training session to allow a new training session to start. A maxi-
mum of 50 laps is possible for each training. Your HR monitor
informs you if the memory is almost full. At this point, at the la-
test, we recommend transmitting the recordings to your PC and
thus emptying the memory on the HR watch. Alternatively you can
delete all recordings manually. Read the section "Delete all
recordings" in this chapter to find out how to delete the recordings.
Training
Start
button you can change
menu, by pressing
Training
34
, your HR
.
menu
8 times.