Installation; Tools And Equipment; Removing The Protective Film; Preparation For Extraction Mode - hanseatic SY-6005B2 Gebrauchsanleitung

Installation

A certain amount of manual dexterity is required for installation. Observe the

Tools and equipment

previously mentioned sequence of installation steps.
Before beginning, have the following equipment available:
– Phillips screwdriver, size 2
– Drill with drill bits: stone ø 8 mm, wood ø 5 mm
– Wall plugs and screws
– Measuring tape/folding ruler
– Spirit level
– Pencil
– Stable ladder
– Air hose, ø 12.5 cm, for extraction mode, or activated carbon filter for
circulating air mode
Some tasks for the installation will be made much easier if a second
Important!
person is available to assist in passing the tools and to hold the
components.
The painted surfaces of your new extraction hood are covered with film to

Removing the protective film

protect it from scratching during transportation. Only remove the protective film
immediately before final attachment of the extraction hood.
Observe that the appliance can have sharp edges on the inside.
Risk of injury!

Preparation for extraction mode

1. Install the covers 5 in the upper and rear air discharge aperture in the
extraction hood 1.
10
1
5
Preparation