Protective Clothing; Emc Device Classification - Parkside Ppsz 700 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

sary, in order to guarantee safety at work and which precautionary
measures should be taken during the actual welding procedure.
z Total of no-load voltages
When more than one welding power source is operated at
„
the same time, their no-load voltages may add up and lead to
an increased electrical hazard. Welding power sources must
be connected in such a way that the danger is minimised.
The individual welding power sources, with their individual control
units and connections, must be clearly marked, in order to be able
to identify which device belongs to which welding power circuit.
z Protective clothing
At work, the welder must protect his/her whole body by using
„
appropriate clothing and face protection against welding sparks
and burns. The following steps must be observed:
Wear protective clothing prior to welding work
–
Wear gloves.
–
Open windows or use fans to guarantee air supply.
–
Wear safety goggles and face mask.
–
Gauntlet gloves made of a suitable material (leather) must be worn
„
on both hands. They must be in perfect condition.
A suitable apron must be worn to protect clothing from flying
„
sparks and burns. When specific work, e.g. overhead welding,
is required, a protective suit must be worn and, if necessary,
even head protection.
PROTECTION AGAINST RAYS AND BURNS
Warn of the danger to the eyes by hanging up a sign
„
saying "Caution! Do not look into flames!" in the work area.
The workplaces must be shielded so that the persons in the vicinity
are protected. Unauthorised persons must be kept away from
welding work.
z EMC Device Classification
According to the standard EN 62135-2 this is a welder in electro-
magnetic compatibility Class A. Class A devices are devices that are
suitable for use in all other areas except living areas and areas that
are directly connected to a low-voltage supply mains that (also)
supplies residential buildings. Class A devices must adhere to the
Class A limit values.
WARNING NOTICE: Class A devices are intended for use in
12
GB/IE/NI/CY/MT