Safety Instructions - Parkside Ppsz 700 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

z Safety instructions
Please read the operating instructions with care and observe
the notes described. Familiarise yourself with the device, its proper
use and the safety instructions using these operating instructions.
The rating plate contains all technical data of this welder; please
learn about the technical features of this device.
„
children. There is a risk of suffocation!
Repairs or/and maintenance work must only be carried out by
„
qualified electricians.
During operation the device should not be covered or jammed
„
between other devices. Make sure that the device is correctly
connected to the mains voltage. Avoid any form of tensile stress
of the power cable.
Only remove the electrodes from the holder after allowing them to
„
cool down for 15 minutes.
Resistance welding creates sparks, molten metal parts and smoke.
„
Therefore ensure that: All flammable substances and/or materials
are removed from the workplace and its immediate surrounding.
Ensure the workplace is ventilated.
„
Do not weld on containers, vessels or tubes that contain or con-
„
tained flammable liquids or gases.
„
welding current circuit. The no-load voltage between the electrode
holders can be dangerous, there is a risk of electric shock.
Do not store or use the device in a damp or wet environment or in
„
the rain. Protection rating IP20 is applicable in this case.
Protect your eyes from welding sparks using certified safety
„
goggles (EN 166). Wear gloves and dry protective clothing that
are free of oil and grease to protect the skin from welding sparks.
„
pipes.
Keep any body parts away from the space between the welding
„
arms. Risk of crushing! Do not touch the welding arms. Risk of
electric shock! Risk of burns!
Please note:
Resistance welding creates sparks and drops of melted metal.
„
The welded workpiece starts to glow and remains hot for a
8
GB/IE/NI/CY/MT
Keep the packaging material away from small
Avoid any form of direct contact with the
Do not use the welding power source to defrost