Operation; Setting The Rotating Direction; Torque Control; Switching On And Off - Parkside Performance Pabsp 20 Li C3 Kurzanleitung/Originalbetriebsanleitung

Before operating the product, check whether the accessory
tool is correctly positioned, i.e. centred in the chuck
Screw bits are labelled according to their dimensions and
their shape. If you are uncertain, always check whether the
bit fits tightly in the screw head without any free play.
˜ Operation
˜ Gear selection
m
ATTENTION! RISK OF PRODUCT DAMAGE!
Do not operate the gear selector
product has come to a standstill.
Change the gear by sliding the gear selector
or backwards (fig. F).
1 gear:
st
Suitable for:
Speed:
Torque:
2 gear:
nd
Suitable for:
Speed:
Torque:
˜ Setting the rotating direction
m
ATTENTION! RISK OF PRODUCT DAMAGE!
Do not operate the rotation direction switch
until the product has come to a standstill.
Change the direction of rotation by pressing the rotation
direction switch towards the left or right (fig. G).
[ 5 ]
When the rotation direction switch
position, the on/off switch
˜ Torque control
This product is equipped with a torque control that disengages
the spindle when a predefined torque is exceeded.
The torque can be adjusted by turning the torque sleeve
(fig. H).
Small screws or soft materials: Select a low level.
Large screws, hard materials or removing screws: Select a
high level.
For drilling operation: Turn the torque sleeve
position.
.
[ 1 ]
until the
4 ] [
forwards
[ 4 ]
Screwing
Low
High
Drilling
High
Low
5 ] [
is in the middle
[ 5 ]
is locked.
[ 6 ]
to the
[ 3 ]
˜ Switching on and off
NOTE
The on/off switch
[ 6 ]
Switching on: Press and hold the on/off switch
Regulate the speed as required (see "Speed control")
(fig. I).
Switching off: Release the on/off switch
˜ Speed control
By using the on/off switch
control the speed:
Pressure
Gentle pressure:
Greater pressure:
˜ LED work light
This product is equipped with a LED work light
the immediate working area to improve visibility in poorly lit
areas.
The LED work light
the product is switched on.
NOTE
The LED work light
u
approx. 10 seconds after switching off the product.
˜ Working instructions
Torque
Smaller screws/bits can be damaged if you set the torque
or rotational speed too high.
Hard screw joints (in metal)
Particularly high torque occurs, for example in metal screw
joints made using drive sockets. Select a low rotational
speed.
Soft screw joints (e.g. in soft wood)
Again, use a low rotational speed, e.g. to avoid damaging
the surface of the wood upon contact with the screw head.
Use a countersink.
3 ] [
Drilling in wood, metal and other materials
Use a high speed for drill bits with small diameter and a
low speed for drill bits with large diameter.
Select a low speed for hard materials and a high speed for
soft materials.
Secure or fasten the workpiece in a clamp or vice (if
possible).
cannot be locked.
.
[ 6 ]
, you can progressively
6 ] [
Speed
Lower speed
Higher speed
to illuminate
[ ]
lights up automatically as soon as
[ ]
stays on for an additional
[ ]
.
[ 6 ]
GB 17