Cordless Drill; Reconnecting The Cordless Drill; Reset To Factory Original Setting; Privacy Policy - Parkside Performance PABSP 20 Li C3 Bedienungsanleitung Und Originalbetriebsanleitung

{Firmware version}
Checking the firmware version of the power
o
tool:
– If a red dot is displayed next to the version
it indicates that a new firmware version is
available. When you select
version}, you can select
firmware}. The update status bar shows
the transmission of new firmware to the
battery pack.
{Update success}
o
transfer of the new firmware to the battery
pack. The battery pack disconnects from the
Lidl Home app. The firmware update will
start.
m IMPORTANT!
During the firmware update the connection
u
status LED flashes 5× per second. Do
[ ]
not disconnect the smart battery pack
from the cordless drill during the update
as the cordless drill will become unusable
if the update fails. During the update the
cordless drill becomes unresponsive to
input, e.g. triggering the on/off switch. The
update process takes around 5 minutes.
If the firmware update is successful, the
connection status LED flashes 1× per
second for 5 seconds. The cordless drill
becomes responsive to input again. You
can connect the battery pack to the
Lidl Home app following the chapter
"Connecting the product to the Lidl Home
app".
˜ Reconnecting the cordless drill
IMPORTANT!
m
If the connection status LED
u
alternatively between 1× and 5×
per second, it means the connection
was disrupted. One of the reasons is
disconnecting the battery pack from the
cordless drill during firmware update. The
cordless drill will not be usable until you
re-established the connection it.
48 GB/IE
{Firmware
{Update of
means successful
flashes
[ ]
Proceed as follows to re-establish the connection
with the cordless drill:
1. Attach the battery pack to the cordless drill.
2. Press the on/off switch
status LED
flashes alternatively 1× or 5×
[ ]
per second.
3. Enable Bluetooth
®
4. Press and hold the
level) on the smart battery pack for 3 seconds
to ensure that Bluetooth
battery pack.
5. Connect the battery pack to the Lidl Home
app following the chapter "Connecting the
product to the Lidl Home app".
{Device info}
6. Select
"PABSP 20 Li C3 (2207)" under {Battery}.
The overview page of the cordless drill is
displayed.
{Firmware
7. Select
firmware.
8. After successfully updating the firmware, the
connection with the cordless drill should be
re-established and the cordless ready for use.
˜ Reset to factory original
setting
{Reset}
Select to restore the firmware to
o
original factory setting.
˜ Privacy policy
You can find the complete data protection
guideline under the tab
{{guideline}.
˜ Disconnecting the product and
deleting data from the app
1. In the tab, select the product that you
want to remove and whose data you want to
delete.
2. Select the icon in the top right.
. The connection
6 ] [
on your mobile product.
button (charging
is activated on the
®
version}
and update the
{Data protection}