Mounting; Adhesive Strip Mounting - HomeMatic HmIP-WRC6 Montageanleitung Und Bedienungsanleitung

5.2

Mounting

Please read this entire section before starting to
mount the device.
You can use the supplied clip-on frame (A) to mount the
wall-mount remote control or easily integrate it into an
existing switch (see sec. „5.2.3 Installation in multiple
combinations" on page 40).
If you want to mount the wall-mount remote control
with the supplied clip-on frame, you can use
• the supplied double-sided adhesive strips or
• the supplied screws
to fix it to a wall.
5.2.1

Adhesive strip mounting

For mounting the assembled device with adhesive strips,
please proceed as follows:
• Choose a site for installation.
Make sure that the mounting surface is smooth,
solid, non-disturbed, free of dust, grease and sol-
vents and not too cold to ensure long-time ad-
herence.
Fix the adhesive strips (H) on the back side of
•
the mounting plate (G) in the provided area. You
Start-up
37