Overview And Connections; Start-Up; Wall Mounting - HomeMatic CCU2 Bedienungsanleitung

house
• Establishing direct links between HomeMatic devices that remain
active even without the involvement of the Central Control Unit
• Setting up complex control tasks and individual logic functions via
Central Control Unit programs.
5

Overview and connections

Micro-SD
A
Power
B
Internet
C
Info
D E
(A) Power LED
(B) Internet LED
(C) Info LED
(D) Recovery button
(E) microSD/SDHC card slot
(F) Power supply cable
(G) USB device interface
(H) USB host interface
(I) Network cable
32
F G H I
6

Start-up

6.1

Wall mounting

Please use the two screws and plugs supplied for wall mounting.
When selecting a mounting location and drilling in the vicinity
of switches or socket outlets, make sure that there are no
cables in the wall.
Do not mount the Central Control Unit in the vicinity of other
sources of interference (e.g. WLAN or DSL routers). For
notes on rectifying malfunctions, see Section 10.
• Hold the drilling template supplied (see additional sheet) at your
intended mounting location and align it vertically and/or horizon-
tally.
• Use a pen to mark the bore holes A and B (as shown on the
drilling template) on the wall through the template.
• Drill the two marked holes into the wall with a diameter of 5 mm.
Insert the plugs in the holes. Turn the screws into the plugs so
that they protrude from the wall by approx. 1.5 mm. Working from
above/from the right, hang the device using the brackets on the
back (J) (see page 34) behind the screw heads.
33