Maxi-Cosi Mobi Bedienungsanleitung Seite 7

The Maxi-Cosi Mobi (XP) has extra anchor points that you can use to tether the Maxi-Cosi Mobi (XP) if no
anchor points are available in your car. There are several options for doing this.
Study the bottom of the car seat and the seat rails and choose the right configuration for installation; car kit or
metal attachment hooks (both included).
a) Car kit
The (below) chart shows all possible configurations for installing the car kit components.
To obtain the right length, a suitable opening in the tether must be chosen (16).
16
• IMPORTANT! Determine the length based on the position of the Maxi-Cosi Mobi (XP) in the car (rear, middle
or front seat).
• Simply hook the tether hook onto the anchor point (17).
17
• IMPORTANT! Make sure the tether straps and car kit components are not twisted.
• Wait with tightening the tethers until after Step 4; Positioning the support leg.
b) Metal attachment hooks
Car kit components
braided together as
single component
Car kit components
attached separately
If you can see a bolt holding down the seat rail you can use the metal attachment hooks as separate anchor loops.
• Ask your car dealer to connect the metal attachment hooks to the bolt (18).
18
• IMPORTANT! Ask your certified car dealer to connect the metal attachment hooks. Changes to the car done
by yourself can affect the warranty conditions of your car.
• Simply hook the tether hook onto the metal attachment hooks (19).
19
• IMPORTANT! Make sure the tether straps are not twisted.
• Wait with tightening the tethers until after Step 4; Positioning the support leg.
Instructions for use
Maxi-Cosi Mobi
on
FRONT SEAT
1
2
3
2x
1
2
3
Maxi-Cosi Mobi
Maxi-Cosi Mobi
on
on
MIDDLE SEAT REAR LEFT/
RIGHT SEAT
EN
11