Installing And Removing The Maxi-Cosi Mobi (Xp); Installing The Maxi-Cosi Mobi (Xp) - Maxi-Cosi Mobi Bedienungsanleitung

2. INSTALLING AND REMOVING THE Maxi-Cosi Mobi (XP)

The Maxi-Cosi Mobi (XP) can be installed with an automatic 3-point or 2-point safety belt in combination
with the tethers and support leg. To check whether your car is suitable for installing the Maxi-Cosi Mobi (XP)
with tethers and support leg, see Chapter 9: Car list.
Never use the Maxi-Cosi Mobi (XP) on seats equipped with frontal airbags! This does not apply to side
airbags. Frontal airbags must be switched off when the car seat is in the front passenger seat. The
manufacturer advises that frontal airbags will be switched off or disabled by an official car-brand-dealer.
The Maxi-Cosi Mobi (XP) is only suitable for use in the listed vehicles fitted with dynamic 3-point or static
2-point safety belts, approved in accordance with ECE Regulation No. 16 or equivalent standard.
The proper threading of the seat belt is essential to your child's safety. The seat belt must be threaded along
the blue markings on the Maxi-Cosi Mobi (XP). Never thread the belt in any other way!
Mobi

2.1 Installing the Maxi-Cosi Mobi (XP)

Semibold Italic 36 pt
Mobi XP
Step 1: Adapting the harnesses to your child
Before installing the Maxi-Cosi Mobi (XP), you will need to determine the proper height of the shoulder
belts for your child. The Maxi-Cosi Mobi (XP) has 3 slots for the shoulder belts. Smaller children should use
Mobi
the lowest slots, while older children should use the top slots. Use the middle slot for children of medium
Semibold Italic 36 pt
Mobi XP
height, making sure the slot used is not below the child's shoulders.
Mobi
Semibold 36 pt
• Loosen the shoulder belts by pressing the adjustment button and pulling the shoulder belts towards you (1).
Mobi XP 1
• IMPORTANT! Do not pull on the belt pads.
• Release the belt buckle by pressing the red button on the buckle (2). Drape the belts over the belt hooks
2 3
on the shell and flip away the belt buckle (3).
• Position your child in the Maxi-Cosi Mobi (XP) with his back straight up against the backrest.
• Adjust the height of the shoulder belts to a suitable height for your child (4).
4
• IMPORTANT! The correct height of the shoulder belts is attained when the belt disappears into the shell
slightly above the shoulders of the child.
• Remove your child from the Maxi-Cosi Mobi (XP).
Instructions for use
• Installed with 3-point
safety belt
• Installed with static 2-point
safety belt
• On passenger seat
• On left/right side of the back seat
• In the middle position of the back seat
• Rearward-facing
• Forward-facing
• Belt routing marking
• Frontal airbag
• Side airbag
Yes
Yes EN
Yes
Yes
Yes
Yes
No
Blue
No
Yes
9