Required preliminary setting if not using Live View mode
1. In the main camera menu, (see p. 150/240) select
(page 1, section
Exposure metering
2. in the sub-menu select
–
shutter metering, for the conventional metering
Classic
method described above, or
–
sensor metering if you want to be able to choose
Advanced
between the three metering methods described below.
Notes:
• In Live View mode, the three metering methods are always
available, i.e. even if
Classic
• With the third sub-menu option –
function of the
LV
button can be disabled.
Selecting the metering method
1. In the picture parameters menu (see p. 150/240) select
and
Exposure Metering
2. select the desired metering method in the sub-menu:
–
Only a small area in the center of the image is
Spot
captured and evaluated. This area is indicated by the
rectangle in the center of the monitor image.
–
Similar to the
Center-weighted
weighting described above.
–
This metering method is based on detection of
Multi-field
multiple metered values. The values are used in an algorithm
to calculate an exposure value appropriate to the situation,
resulting in correct reproduction of the assumed main
subject.
• The set metering method is specified in the monitor in live
view and video mode, and in the extended (
(see p. 234).
), and
CAMERA
is set.
– the
Classic/ LV deactivated
- centering
Classic
INFO
) display
Notes:
• For the metering methods based on the image sensor, the
shutter must be open and it is then closed and re-cocked when
the function is canceled. Of course, this is audible and may
result in a slight delay in the shutter release.
• Frequent use of the Live View mode results in increased power
consumption.
The appropriate shutter speed for correct exposure, or the
variation from a correct exposure setting, are specified or
determined using displays in the viewfinder or monitor (see
following sections).
EN
175