Leica M Monochrom Anleitung Seite 165

EN Note:
By factory default, the
.
12500
To restrict the automatic setting range
4. In this sub-menu, select
.
exposure time
5. In the
Maximum AUTO ISO
sensitivity to be used, and hence the range within which the
automatic setting is to operate, or in the
sub-menu set either one of the three focal length-specific
time
settings -
1/focal length
if you wish to leave it to the camera to ensure wobble-proof
shutter speeds, or the slowest shutter speed that you wish to
set ( / s - / s in whole steps). In the focal length-specific
1 1
2 500
settings, the camera only switches to a higher sensitivity if the
shutter speed would fall below the threshold due to lower
brightness, e.g. with a 50mm lens at slower speeds than
at
1/focal length
1/4xfocal length
6. Confirm your setting with the
162
function is limited to
Maximum ISO
and/or
Maximum AUTO ISO
sub-menu, select the highest
Maximum exposure
, ,
1/ 2xfocal length 1/4xfocal length
, or / s at , or
1 1/2xfocal length
125
.
INFO or SET button.
Specifying AUTO ISO mode in manual exposure setting
4. In this sub-menu select
ISO
.
Previous
5. If you select
within the limit you specified in the
sub-menu item). If you select
Maximum
set sensitivity will be used.
6. Confirm your setting with the
Note:
The following rule applies when using automatic bracketing (see p.
180):
2
The sensitivity automatically determined by the camera for the
uncorrected picture is also used for all other pictures in a series,
i.e. this ISO value is not changed during a series. This may mean
that the slowest shutter speed specified under
is exceeded.
time
/ s
1
60
/ s at
1
250
This function requires the use of coded lenses or setting of the lens type used in
2
the menu (see p. 158).
AUTO ISO in M mode
.
ISO
, automatic control is active (where appropriate
On
Maximum AUTO ISO
Previous ISO.
or
INFO SET
, and then or
On
the last manually
button.
Maximum exposure