Using House Current - Sony Ruvi CCD-CR1E Bedienungsanleitung

Using house current

When you install or remove the battery shaped block of the connecting cord, turn off
the camcorder to prevent misoperation of the camcorder.
(1) To open the lid of the battery compartment, slide the OPEN (BATT) release
(2) Install the battery shaped block of the DC connecting cord in the direction of
(3) Connect the DC connecting cord to the AC adaptor/charger.
(4) Connect the power cord to the AC adaptor/charger and a wall outlet.
1
3
WARNING
The power cord must be changed only at a qualified service shop.
Note
Keep the AC adaptor/charger away from the camcorder if the picture is affected.
10
EN
lever at the bottom of the camcorder to the left, then slide it toward you and
release.
the arrow. Open the cord cover and pass the cord through. Then close the lid
and slide it until it clicks.
2
4