Getting Started; Installing The Batteries; Battery Life - Sony Ruvi CCD-CR1E Bedienungsanleitung

Getting started

Installing the batteries

Before using your camcorder, you first need to install two LR6 (size AA) Sony batteries
or the charged battery pack. Use the supplied LR6 (size AA) Sony batteries or the NP-
F10 "InfoLITHIUM" battery pack.
When you install or remove the batteries, be sure to turn off the camcorder to prevent
misoperation of the camcorder.
You can also use house current as a power source. (P. 10)
(1) To open the lid of the battery compartment, slide the OPEN (BATT) release
(2) Install two LR6 (size AA) batteries or the battery pack in the direction of the
1
2
Note on LR6 (size AA) batteries
•Be sure to install two LR6 (size AA) batteries with correct polarity.
•You can not use LR6 (size AA) batteries in a cold environment. Use the NP-F10 battery
pack .

Battery life

When using two LR6 (size AA) Sony batteries or the NP-F10 rechargeable battery pack:
Battery
Continuous recording
time*
Typical recording time**
Playing time on LCD
Numbers in parentheses of NP-F10 indicate the time when you use a normally charged
battery.
* Approximate continuous recording time at 25°C (77°F). Battery life will be shorter if
you use the camcorder in a cold environment.
** Approximate minutes when recording while you repeat recording start/stop and
turning the power on/off. The actual battery life may be shorter.
8
EN
lever at the bottom of the camcorder to the left, then slide it toward you and
release.
arrow. Then close the lid and slide it until it clicks.
LR6 (size AA) batteries
60 minutes
30 minutes
60 minutes
NP-F10
90 (80) minutes
50 (45) minutes
90 (80) minutes