Information For Use; Intended Use - Konig & Meyer Easy Lock Nutzungsinformation

24633 Speaker stand
24633 »Easy Lock«

Information for use

Intended use

The speaker stand is used to hold and lift speakers and other equipment in event technology and
production areas with a maximum weight of 18 kg. The tension clamp with safety hook allows for
fast, simple height adjustment in five steps. The patented »Easy Lock« system makes it possible
to place speakers on the speaker stand without any play, extremely fast and in just one motion.
The movable plastic splints provide for a vibration-free connection between the speaker and
stand. The speaker stand can accommodate speakers with a flange bushing diameter of 35 to
37 mm. Thanks to the flat base plate with carrying handle, the stand can be easily transported
and used in a small space. The cable opening with edge protection allows cables to be routed
under the base plate.
Foreseeable misapplication
Do not open the clamping screw or screw fixing between the base and tube combination during
use. The load capacity of the stand must be observed.
General
u The speaker stand must be placed on an even surface that can hold the weight involved.
u The load capacity of the speaker stand must not be exceeded.
u Do not set up the speaker stand in escape routes or areas accessible to the public.
u Protect the stand from the effects of weather. The speaker stand is not designed for
u
permanent outdoor operation.
u Do not use the speaker stand if it is visibly damaged or shows signs of wear.
u The installation height creates a risk of falling parts.
u Personal injury or property damage may occur if the speaker stand falls over or down.
u Due to the adjustability of the components, there is finger trap risk between the components.
u The user should be physically fit and technically competent.
u The usage information is an integral part of the product and should be kept for its service life
u
or passed on to any subsequent owner or user.
Warranty
No warranty is given for damage caused by:
u Non-observance of the usage information and the "General safety and assembly instructions".
u Unsuitable or improper use.
u Incorrect installation or commissioning by the buyer or third parties.
u Natural wear and tear.
u Careless handling.
u Improper modifications or repair work by the buyer and third parties.
u Impact on components of foreign origin.
u Use of non-original spare parts.
Modifications, additions and conversions that may impair safety are prohibited without the manu-
facturer's approval.