Information For Use; Intended Use - Konig & Meyer Easy Lock 21439 Nutzungsinformation

21439 Speaker stand
21439 »Easy Lock«

Information for use

Intended use

The stand is used to hold and lift speakers and other equipment in event technology with a maxi-
mum weight of 50 kg. The tension clamp with safety hook allows for fast, simple height adjust-
ment in five steps. The patented »Easy Lock« system makes it possible to place speakers on a
stand without any play, extremely fast and in just one motion. The movable plastic splints provide
for a vibration-free connection between the speaker and stand. The speaker stand can accom-
modate speakers with a flange bushing diameter of 35 to 37 mm.
Foreseeable misapplication
Clamping screws must not be opened during use. The load capacity of the stand must be obser-
ved.
General
u The stand must be placed on an even surface that can hold the weight involved.
u The load capacity of the stand must not be exceeded.
u Do not set up the stand in escape routes or areas accessible to the public.
u Protect the stand from the effects of weather. The stand is not designed for permanent outdoor
u
operation.
u Do not use the stand if it is visibly damaged or shows signs of wear.
u The installation height creates a risk of falling parts.
u Personal injury or property damage may occur if the speaker stand falls over or down.
u Due to the adjustability of the components, there is finger trap risk between the components.
u The user should be physically fit and technically competent.
u The usage information is an integral part of the product and should be kept for its service life
u
or passed on to any subsequent owner or user.
Warranty
No warranty is given for damage caused by:
u Non-observance of the usage information and the "General safety and assembly instructions".
u Unsuitable or improper use.
u Incorrect installation or commissioning by the buyer or third parties.
u Natural wear and tear.
u Careless handling.
u Improper modifications or repair work by the buyer and third parties.
u Impact on components of foreign origin.
u Use of non-original spare parts.
Modifications, additions and conversions that may impair safety are prohibited without the manu-
facturer's approval.