Information For Use; Warranty - Konig & Meyer 19784 Nutzungsinformation

19784 Camera stand

Information for use

Intended use
The camera stand with a 1/4" threaded connection is designed to support compact cameras,
action cameras, web cams, mini-projectors and mobile recorders. Thanks to the ball joint the
mounted devices can be rotated by 360° and clamped in any position. The incline is stepless a
djustable by 90°. The height is adjustable from 555 mm up to 1355 mm via two clamping screws.
The camera stand is construed for a load capacity of 1 kg.
Foreseeable misapplication
Do not transport the tripod when equipped. Do not open the clamping screws without holding the
mounted equipment.
General
u The stand should be placed on a level and stable flooring. The diameter of the base should be
u
set as far as possible.
u The user should be physically fit and technically competent.
u The device to be mounted should be equipped with a 1/4" thread. Follow the respective
u
operating instructions or assembly instructions regarding the device. The maximum screw
u
penetration must be observed otherwise it may damage the equipment.
u The mounted device should be placed as centrically as possible on the tripod to avoid
u
increased risk of tipping.
u Injuries und damages can be caused to individuals or property if the camera stand should tip
u
or fall.
u Due to the adjustability of the components, there is finger trap risk between the components.
u The usage information is an integral part of the product and should be kept for its service life
u
or passed on to any subsequent owner or user.

Warranty

No warranty is given for damage caused by:
u Non-observance of the usage information and the "General safety and assembly instructions".
u Unsuitable or improper use.
u Incorrect installation or commissioning by the buyer or third parties.
u Natural wear and tear.
u Careless handling.
u Improper modifications or repair work by the buyer and third parties.
u Impact on components of foreign origin.
u Use of non-original spare parts.
Modifications, additions and conversions that may impair safety are prohibited without the manu-
facturer's approval.