Toro 38816 Bedienungsanleitung Seite 20

Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the first 2 hours
After the first 5 hours
Before each use or daily
Every 25 hours
Yearly
Yearly or before storage
Important: You can find more information about maintaining and servicing your machine at www.Toro.com.
Important: Refer to your engine operator's manual for additional maintenance procedures. For engine adjustments,
repairs, or warranty service not covered in this manual, contact an Authorized Briggs & Stratton Servicing Dealer.
Maintenance Procedure
• Inspect the traction cable and adjust it if necessary.
• Inspect the auger/impeller cable and adjust it if necessary.
• Change the engine oil.
• Check the engine oil level and add oil if necessary.
• Change the engine oil.
• Check the skids and the scraper and adjust them if necessary.
• Inspect the traction cable and adjust or replace it if necessary.
• Inspect the auger/impeller cable and adjust or replace it if necessary.
• Check the auger gearbox oil and add oil if necessary.
• Check the air pressure in the tires and inflate them to 17–20 psi (116–137 kPa).
• Drain the gasoline and run the engine to dry out the fuel tank and the carburetor at
the end of the season.
• Have an Authorized Service Dealer inspect and replace the traction drive belt and/or
the auger/impeller drive belt, if necessary.
20