Toro 38816 Bedienungsanleitung Seite 17

Operating the Traction Drive
CAUTION
If the traction drive is not properly adjusted, the
machine may move in the direction opposite of
what you intended, causing injury and/or property
damage.
Carefully check the traction drive and adjust it
properly, if necessary; refer to Checking the Traction
Drive Operation in Setup for more information.
Important: If the machine moves when the traction
lever is in the released position, check the traction cable
(refer to Checking and Adjusting the Traction Cable) or
take the machine to an Authorized Service Dealer for
service.
1. To engage the traction drive, squeeze the left hand
(traction) lever to the hand-grip (Figure 29).
2. To stop the traction drive, release the traction lever.
Figure 29
Operating the Speed Selector
The speed selector has 6 forward and 2 reverse gears. To
change speeds, release the traction lever and shift the speed
selector lever to the desired position (Figure 30). The lever
locks in a notch at each speed selection.
Operating the Auger/Impeller
Drive
1. To engage the auger/ impeller drive, squeeze the
right hand (auger/ impeller) lever to the handgrip
(Figure 31).
2. To stop the auger and impeller, release the right hand
lever.
Important: When you engage both the
auger/impeller lever and the traction lever, the
traction lever locks the auger/impeller lever down,
freeing your right hand. To release both levers,
simply release the left hand (traction) lever.
3. If the auger and impeller continue to rotate when you
release the auger/impeller lever, do not operate the
machine. Check the auger/impeller cable (refer to
Checking and Adjusting the Auger/Impeller Cable)
and adjust it if necessary. Otherwise, take the machine
to an Authorized Dealer for service.
17
Figure 30
Figure 31