Herunterladen Diese Seite drucken

Toro 38816 Bedienungsanleitung Seite 10

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

3
Installing the Chute
Parts needed for this procedure:
2
Nut
2
Carriage bolt
2
Flat washer
Procedure
1. Place the chute on the frame and the align the discharge
chute mount to the chute support.
1
1. Carriage bolt
2. Flat washer
2. Secure the discharge chute mount using 2 bolts, 2 nuts,
and 2 flat washers.
3
2
g019379
Figure 8
3. Nut
4
Installing the Chute Control
Rod
Parts needed for this procedure:
2
Carriage bolts
2
Locknuts
Procedure
1. Unwrap the Quick Stick and rotate it so that it is
upright and in the center.
2. Hold the blue trigger cap down and pull the lever fully
rearward.
Note: The discharge chute and deflector should face
forward. If they do not, hold the blue trigger cap
down (but do not move the Quick Stick) and rotate the
discharge chute until they do.
3. Align the flattened back end of the long chute control
rod with the flattened front end of the short rod
that extends from the control panel so that they nest
together (Figure 9).
1. Short rod
4. Insert the front end of the rod into the opening in
the back of the chute gear cover until it slides into the
chute gear (Figure 10).
10
Figure 9
2. Long chute control rod

Werbung

loading

Diese Anleitung auch für:

Power max 726 oe