Dometic CK-Serie Bedienungsanleitung Seite 11

Connecting to an AC power supply
D
DANGER! Electrocution hazard
• Never handle plugs and switches with
wet hands or if standing on a wet sur-
face.
• If the cooler is operated on AC power
supply on board a boat, a residual cur-
rent circuit breaker must be installed
between the AC power supply and the
cooler.
Seek advice from a trained technician.
➤Connect the cooler to an AC power supply
(fig. 3, page 4).
Using the lid
➤Open the lid by pushing the handle upwards
and flipping the lid upwards at the same time.
➤Ensure that a clicking sound is heard when the
lid is closed.
Removing and reassembling the lid
1. Open the lid completely (chapter "Using the
lid" on page 11).
2. Pull off the lid by pushing it upwards beyond
the lid stop position.
3. Proceed in reverse order when reassembling.
Switching on/off
I
NOTE
When operating with the battery, the dis-
play switches off automatically.
➤Press the ON/OFF button to switch the cooler
on or off.
✔ The display shows the current cooling tempera-
ture in °C when it is switched on.
➤Unplug the cooler when it is switched off and
not in use.
➤Clean the cooler if it is not in use (chapter
"Cleaning and maintenance" on page 12).
➤For storage wrap the power cable around the
bracket on the back of the cooler
(fig. 4, page 4).
EN
Setting the temperature
The cooling capacity can be influenced by:
• The ambient temperature
• The number of bottles to be cooled
• The frequency with which the lid is opened
Decreasing the temperature
1. Press the "SET" button.
2. Press "–" on the temperature button to
decrease the current cooling temperature by
1 °C.
✔ The cooler acknowledges the chosen tempera-
ture's acceptance by flashing the display.
✔ The cooling temperature set.
✔ The temperature appears on the display for a
few seconds.
Increasing the temperature
1. Press the "SET" button.
2. Press "+" on the temperature button to
increase the current cooling temperature by
1 °C.
✔ The cooler acknowledges the chosen tempera-
ture's acceptance by flashing the display.
✔ The cooling temperature set.
✔ The temperature appears on the display for a
few seconds.
Using the handles
The cooler can be transported by its handles.
➤Use the handles as shown in fig. 5, page 5.
Using the table function
A
NOTICE! Damage hazard
• Do not place sharp or hot objects on
the cooler.
• Place only food on a plate, in trays,
wrappers or similar on the cooler.
The cooler can be used as table (fig. 6, page 5).
1. Close the lid of the cooler.
2. Place the food, beverages, cutlery, etc. on the
lid.
4445103834 11