Charging Nicd/Nimh Battery; Discharging Nicd/Nimh Batteries - ANSMANN xBase 2.0 Bedienungsanleitung

14. Charging NiCd/NiMH Battery

15. Discharging NiCd/NiMH Batteries

Balance Charger xMove 2.0/xBase 2.0 13
This program simply charges the battery using the current you set. In
'Aut' mode, you need to set the upper limit of charge current to avoid
form higher feeding current that may damage the battery. Because
some batteries of low impedance and small capacity can lead to the
higher charge current by the processor at automatic charge mode.
But in 'Man'mode, it will charge the battery with the charge current
you set at the display. Each mode can be switched by pressing
INC ► and ◄ DEC button simultaneously when the current field is
blinking.
The screen displays the current state of charging. To stop the process,
press "Batt type/Stop" key once.
The audible sound indicates you the end of process.
Set discharge current on the left and final voltage on the right. The
discharge current ranges form 0.1 to 1.0 A and the final voltage
ranges form 0.1 to 25.0 V. To start the process, press "Start/Enter"
key for more than 3 seconds.
The screen displays the current state of discharge. You can alter
the discharge current by pressing "Batt type/Stop" key during the
process. Once you change the current value, store it by pressing "Batt
type/Stop" button again.
To stop discharging press "Batt type/Stop" key once. The audible
sound indicates you at the end of process.