Fast' Charge Lithium Battery; Storage' Control Lithium Battery - ANSMANN xBase 2.0 Bedienungsanleitung

10. 'FAST' Charge Lithium Battery

The charging current is getting smaller as the process goes to the near
end term of Lithium battery charging. To finish the charging process
earlier, this program eliminates certain terms of CV process.

11. 'STORAGE' Control Lithium Battery

This is for charging or discharging Lithium batteries not to be used for
the time being. The program will determine to charge or discharge
the battery to the certain voltage depending on the voltage of the
battery at its initial stage.
Balance Charger xMove 2.0/xBase 2.0 11
Actually, the charging current will go to 1/5 form the initial value
to end the process while the normal charging goes to 1/10 during
CV term. The charging capacity may be a bit smaller than normal
charging but the process time will be reduced.
You can set up the charging current and the voltage of the battery
pack being charged. As you press the "Start/Enter" button the
voltage confirmation will be displayed. And then, if you confirm
the voltage and current, press "Start/Enter" button again to start
charging.
This is shows the present state of 'FAST' charging. To stop charging
arbitrary, press "Batt type/Stop" key once.
They are different form the type of the battery, 3.75 V for Lilo,
3.85 V for LiPo and 3.3 V for LiFe per cell. If the voltage of the
battery at its initial stage is over the voltage level to storage, the
program will start to discharge.
You can set up the current and the voltage of the battery pack to be
charged. The current will be used for charge or discharge the battery
to reach the 'storage' level of voltage.
The screen shows the present situation during charge process. To stop
charging press "Batt type/Stop" key once.