Exterior Of The Unit - ANSMANN xBase 2.0 Bedienungsanleitung

Input power monitor: To protect the car battery using as DC input
power from being damaged the voltage of it always monitored. If it
drops below the lower limit the process will be ended automatically
Data store/load
For users convenience it can store maximum five data of different
batteries. You can establish the data contains program setting of the
battery to charge or discharge continually. These data can be called
out at any tine you need, and the process can be executed without
program setting.
Cyclic charging/discharging
Perform 1 to 5 cycles of charge > discharge or discharge > charge
continually for battery refreshing and balancing.

2. Exterior of the Unit

Input power cable
(DC11∼18 V)
3-pin port for
temperature sensor
or USB
Battery type/Stop
To select main program
To stop the operation
Balance Charger xMove 2.0/xBase 2.0
PC based analysis using USB
communication
For technical experts, xMove 2.0/xBase 2.0 offers a PC based
program that can analyse the characteristic of the battery by USB
port. It shows a graph of voltage, current, capacity and temperature
curves. It also shows the individual voltage of each cell in the Lithium
battery pack.
Start/Enter
To resume or start the
operation
< Dec/Inc >
To select sub program
To alter the value
LCD screen
(16 chr. x 2 lines)
Fig. 153000030
Output
Charging lead connector
(4 mm banana female)
3