Kessel EasyClean free Mix & Pump Einbau- Und Betriebsanleitung Seite 18

2 Safety
2.1 General safety notes
WARNING
Live parts
Heed the following points when working on electrical cables and connections.
The national regulations concerning electrical safety apply to all connections and installation work.
The system must be supplied through a residual current protection device (RCD) with residual current of not
more than 30mA.
CAUTION
Hot surfaces!
The drive motor can develop a high temperature during operation.
Wear protective gloves.
CAUTION
Danger of slipping due to fatty liquid. The floor can be wet with fatty liquid during cleaning or disposal.
► Remove liquid spills, wear suitable footwear.
Prescribed personal protective equipment!
Always use personal protective equipment during installation, maintenance and disposal work on the system.
Protective clothing
Protective gloves
Safety footwear
Face protection
Operating and maintenance instructions must be kept available at the product.
2.2 Personnel - qualification
The relevant operational safety regulations and the hazardous substances ordinance or national equivalents apply for the
operation of the system.
The operator of the system must:
prepare a risk assessment
identify and demarcate corresponding hazard zones
carry out safety training
secure the system against unauthorised use.
Person
1)
Operating company
Competent expert /
inspector (familiar with,
understands oper-
ating instructions)
Competent skilled per-
son (specialist crafts-
man, in accordance with
installation instructions
and execution standards)
General inspector (in
accordance with EN 1825)
Qualified electrician (accord-
ing to national regula-
tions for electrical safety)
1) Operation and assembly work may only be carried out by persons who are 18 years of age.
18 / 92
Approved activities on KESSEL systems
Visual check
Emptying, clean-
ing (inside), func-
tional check
Installation and operating instructions
Installation, replace-
ment, maintenance
of components,
commissioning
Leak test, checking
on correct design and
proper assembly before
initial commissioning
Work on electrical
installation
016-189_03