STIEBEL ELTRON LWZ 130 Bedienung Und Installation Seite 57

INSTALLATION
Settings
C]O • Language
Set the required language.
Air now rate
Select the air flow rate for the fan settings under "Air flow
rate" with "Flow rate, stage 0" to "Flow rate, stage 3".
01 Enable fan
The fans are deactivated in the delivered
Set the "Enable fan" parameter to "On".
11.2 Recommissioning
Checkwhether filters are fitted in the unit. Never operate the
unit without filters.
Checkwhether the condensate drain hose is damaged or
kinked.
11.3 Appliance handover
Explain the appliance function to users and familiarise them
with how it works.
• Notice
Hand over these operating and installation instructions
to users for safekeeping. All information in these instruc-
tions must be closely observed. The instructions provide
information on safety, operation, installation and main-
tenance of the appliance.
12. Settings
• Notice
Observethe operating instructions. It explains which pa-
rameters can also be set by the appliance user.
12.1 Menus
• Notice
Some parameters are protected by a code. The factory
programmed code for qualified contractors is "I OOO".
• Notice
The parameters shown in
the service department.
Press the "MENU" button to access the
screen.
Description
Menu
Info Information about the actual values of the appliance
Diagnostics Fault messages.operating time. maintenance intervals
• Programs Fan program
Settings Adjustable values and functions
www.stiebel-eltron.com
condition.
can only be adjusted by
grey
menus from the home
12.1.1 "Info" menu
Info
CJE Bypass status
Extract air temp.
C]• Extract air hum.
C]• Extract air dew pt
C]• Outdoor air temp.
C]• Outdoor air hum.
Outdoor air dew pt
C]• Supply air temp.
Exhaustair temperature
C]• Supplyair fan control
Supplyair fan speed
C]• Supply air flow rate
Exhaust air fan control
C]' Exhaust air fan speed
C]• Exhaust air flow rate
C]' Heatingcoil control
C]• Extract air diff. press.
12.1.2 "Diagnostics" menu
Diagnostics
Clu Notification list
Clear notification list
C]' Filter runtime
C]• Filter reset
Filter changeinterval
C]• Deviceoperating time
Fanoperating time
Diagnostics
C]• Clear notification list
To clear the notification list, set this parameter to "On". Press"0K"
to confirm. Afterwards, "Off" is displayed again and the fault mes-
sagesare deleted.
12.1.3 "Programs" menu
Programs
C]• Fanprogram
LWZ 130 | I-WZ 130 Enthalpie
Value
Off I On
rpm
rn3/h
rpm
rn3/h
pa
Value
0-10
Off I On
h
OfflOn
d
Value
Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
Sunday
Monday - Friday
Saturday- Sunday
Monday - Sunday
I LWZ 130 E-W | 57