STIEBEL ELTRON LWZ 130 Bedienung Und Installation Seite 55

INSTALLATION
Installation
Elektr.
Electr.
X18
Passivkühlung
Passive Cooling
Intensivluftung
Intensive Ventilation
X19
Keine Funktion
No Function
Power supply
XI
Programming unit (Safetyextra low voltage)
XII
Window contact (potential-free)
No function
X19
Intensive ventilation (potential-free)
4-pin female connector
xn-I
XII-2
XII-4
Power supply
The appliance is delivered with a power cable without plug.
Strain relief casing
• Notice
Never place the half shells of the strain relief casing to-
gether before you have prepared the cable and connected
the plug.
Line cross-section
Sheath diameter
Insulation stri
Prepare the end of the cable by stripping the sheath and
insulation.
Push the wires into the side of the plug labelled with the
terminal assignment. If necessary, press a screwdriver on the
clamping springs to make it easier to insert the wires.
www.stiebel-eltron.com
Anschluss
Connection
XII
Fernbedienung
Remote Controller
Netzanschluss
Mains Connection
Safety extra low voltage
+5 v DC
2.
2
0.25
mm
mm
mm
Carefully put the plug into the flat insulation semi-shell of
the strain relief casing so that the terminal labelling remains
visible. The locking tabs on the sides of the plug must engage
in the top tabs of the strain relief casing.
Make sure that the strain relief gutter is inserted in the upper
insulation semi-shell of the strain relief casing.
Push the upper insulation semi-shell carefully onto the lower
insulation semi-shell. The locking tabs on the sides of the
lower insulation semi-shell must engage in the recessesof
the upper insulation semi-shell.
Programming unit
SDA
CND
3
SCL
Programming unit
1
Wall mounted enclosure
2
6-pin female connector
3
Connect the bus cable
Connect the bus cable
Safety extra low voltage
Not assigned
Not assigned
GND
SDA
SCL
Connect the female connector to the back of the program-
ming unit.
Click the programming unit carefully into place in the wall
mounted enclosure.
Safety equipment for stove/fireplace operation
Install the safety equipment in such a way that it interrupts
- 1.5
the appliance power supply when required.
4.5 -8
9
I-WZ 130 | I-WZ 130 Enthalpie
1
2
to the ventilation unit.
to the female connector.
6-pin female connector
I LWZ 130 E-W | 55
1
2
3
5
6