Herunterladen Diese Seite drucken

Innotek Command Serie Bedienungsanleitung Seite 10

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 37
english(eng).qxp
10/27/2005
Note: When the dog goes on point, there is a delay before the collar goes into point mode. In
Normal and Silent Mode, the delay is as long as 10 seconds. In Grouse Mode, the delay is as long
as 5 seconds. This feature keeps the pointing mode from activating when the dog stops momen-
tarily.
Programming the collar receiver(s) for tracking
1. Press the round BLUE program button. A solid YELLOW light glows on the transmitter.
2. Select tracking mode by pressing one button in the DOG 1 column that corresponds to the
table above. The YELLOW transmitter light glows GREEN and goes out.
3. To program a second collar receiver, repeat the process, selecting a tracking mode from the
buttons in the DOG 2 column.
Activating the CALL feature
1. Press the BLUE program button. A solid YELLOW light glows on the transmitter.
2. Press Button 4 in the DOG 1 column to locate the primary dog. The continuous tone will sound
until you release the button.
3. Note this step also turns OFF the tracking feature. To turn ON the tracking mode, follow the
procedure, "programming the collar receiver(s) for tracking," above.
Helpful Hints and Training Guide
To get the most out of your new remote trainer, please make sure to follow these steps
before you begin:
• Use conventional training methods to teach your dog what commands you expect it to respond
to. When the dog understands your commands, only then should you introduce the collar.
• Always make sure the collar is functioning properly before you put it on the dog.
• Set the units on the lowest stimulation level. This allows the dog to respond with a light touch
but gives you higher levels if needed.
• Keep sessions brief (10 minutes). After a 30-minute rest period, repeat the training process.
• Have the dog wear the collar for a few hours each day for a week or two before you start using
it for training.
• Put the collar on the dog at least 30 minutes before beginning a training session. This can help
prevent the dog from becoming collar-wise.
• Once you have started a program with your electronic remote trainer, never start a training ses-
sion without it. A good rule would be to simply never take the dog out without the collar on.
• Always end each session on a good note. Have the dog repeat a mastered task. This will keep
the dog's interest for the next training session.
11:39 AM
Page ENG-10
ENG-10

Werbung

loading