Note:
1. Motion Detection mode is operational only while the camera is on. If the camera
is turned off, Motion Detection mode will be inactive.
2. The camera's higher resolutions, specifically 1944P and 1440P HDR, are not
compatible with the pre-recording function associated with Motion Detection.
Therefore, upon activating Motion Detection, the recording resolution will default
to 1440P.
Low Bitrate Recording
When activated, the low bitrate recording mode is indicated by a 1080P 15FPS icon (
on the lower right of the screen for 1080P selections, or a 720P 15FPS icon (
selections.
If the system doesn't detect any movement for five minutes, an icon (
the center of the screen. In this mode, the video resolution defaults to either 1080P
15FPS or 720P 15FPS for recording, and the length of the recording will correspond to
the previously set loop recording duration. Should the camera detect any vibration or
movement, it will exit this standby mode. It will then wait for another five minutes
without movement before re-entering the low bitrate recording mode.
Note: The low bitrate recording feature is only functional when the camera is powered
on. Turning off the camera will disable low bitrate recording.
23
)
) for 720P
) will appear in