Operation - Litecraft BeamX.7 Bedienungsanleitung

OPERATION

This device has several DMX- and Stand-Alone-Modes. In DMX-mode, multiple devices can be connected and
•
controlled by a controller. The device accepts the settings of the DMX-controller, as soon as the corresponding
start address is set.
Slave mode:
•
Connect the DMX-output of the master device (XLR female) to the DMX-input of the slave device (XLR male).
Set the slave device to mode Slave (display shows: <SLAVE>). The slave device accepts all settings of the
master device (such as programm, programm speed, color).
Display description:
•
The display shows the different DMX-modes & the DMX-start address or programm, programm speed, etc.; the
first line shows the mode, the second line the corresponding value.
Button description:
•
Press the MENU button to get access to the menu. Press the UP/DOWN button to select the relevant topic.
Press ENTER button to change the relevant topic; change the relevant topic by pressing UP/DOWN button to
set the DMX-start address or any of the pre-programmed modes or the speed values. Use the UP button to
increase the value. Use the DOWN button to decrease it. Press ENTER button again to save your settings and
get access to next menu.
NOTE!
If you hold the UP or DOWN button for longer, the value changes faster. The device has an automatic storage for all
settings. When you turn the device off and on again, it works with the previously set values. If the unit is not operated or
about 30 seconds, the buttons are locked. Unlock these by pushing one of the backside buttons for about three seconds.
The unit is additionally equipped with an infrared remote control. The use of this infrared remote control is
•
possible in every mode. Point the infrared remote control in direction of the infrared receiver on top of the
fixture. Choose a color or a program by use of the infrared remote control. To leave infrared-mode press the
button "OFF" on the remote control, press one of the backside buttons on the fixture or switch off the unit and on
again by removing the mains plug from the mains.