Safety Notes - Litecraft BeamX.7 Bedienungsanleitung

SAFETY NOTES

Each person which is responsible for the installation, the use or service of this unit must be:
•
qualified
•
has to follow the instructions in this manual.
•
WARNING!
Be careful when using the device. You risk an electrical shock from high voltage, if you touch the wires!
The device has left our company in manufacturer proofed state. To maintain this status and to ensure a
•
permanent safe operation, it is absolutely necessary to follow the safety instructions and warnings in this
manual.
IMPORTANT!
Errors, caused by not following these instructions are not covered by the warranty. The manufacturer will not accept
liability for any resulting defects or problems.
Keep the unit away from radiators or other heat sources!
•
If the unit has been exposed to tremendous temperature changes (e.g. after transportation), do not turn it on
•
immediately. The resulting condensation could damage the unit. Don`t switch unit on until the device reaches
room temperature.
This device belongs to protection class I. Therefore, it is imperative that the green/yellow wire is connected to
•
the earth contact of the plug. The electrical connection must be made by a qualified person.
Make sure that the cable has never been squeezed or damaged by sharp objects. Check the device and the
•
cables regularly.
If the cable is damaged, it must be replaced immediately by the manufacturer, its service agent or a qualified
•
person in order to avoid danger.
Lenses, glasses or UV filters must be replaced if they are visually damaged, or their effectiveness is impaired,
•
e.g. by broken glass or by deep scratches.
Ensure that wires never come in contact with other wires! Handle the power cord and all connections with
•
caution!
Make sure that the line voltage is not higher than the voltage specified in this manual.
•
Disconnect the unit from the AC mains when it is not in use or when cleaning it. Disconnect the connection
•
only by pulling the cable plug.
Using the fixture for the first time, can result in light smoke and odors. This is a normal process and does not
•
constitute a defect.
RISK OF BURNS!
Do not touch the unit during operation! The housing may reach high temperatures.
RISK TO HEALTH!
Never look directly into the light source. Especially epileptics risk an epileptic shock! Disconnect the unit from the AC
mains when not in use or when cleaning it.
Defects caused by modifications of the device by unqualified handling or an unqualified person are not
•
covered by the warranty.
Keep the product away from children and unskilled people.
•
There are no wear parts in the device. Maintenance and service must be performed only by an authorized
•
service partner.
WARNING! Please make sure to read safety instructions for handling of integrated battery in chapter SAFETY
INSTRUCTIONS BATTERY!