Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Start-up
After removing the old thermostat dial you can mount the
Homematic IP Radiator Thermostat with the metal nut (A)
to the radiator valve (see figure 6).
If required, you can use one of the supplied adapters for
Danfoss valves (see „5.2.3 Adapter for Danfoss" on page
44) or the supplied support ring (see „5.2.2 Support
ring" on page 44).
5.2.2
Support ring
The valves from different manufacturers may have toler-
ance fluctuations that make the radiator thermostat more
loosely seated on the valve. In this case, the provided
support ring (I) should be placed into the flange before
mounting the radiator thermostat (see figure 7).
5.2.3
Adapter for Danfoss
One of the provided adapters is required to attach to
Danfoss valves. The assignment of the suitable adapter
to the relevant valve can be found in the following illus-
trations.
Please ensure that you do not trap your fingers
between the two halves of the adapter!
The RA and RAV adapters have been manufactured with
pre-tension in order to provide a better seat. Use a screw-
driver during installation if necessary, and bend it open
slightly in the vicinity of the screw (see following figures).
44
Werbung
