Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦
Push the rotation direction switch
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack
♦
Press the release button
battery pack
.
Checking the battery charge level
♦
Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Use
Switching on and off
Switching on
♦
To start the appliance, press the ON/OFF
switch
and keep it pressed in.
The LED working light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions.
Switching off
♦
Release the ON/OFF switch
appliance.
│
GB │ IE
■
8
into the
and remove the
to
as follows:
lights up when the
is depressed lightly or fully.
to switch off the
Setting/preselecting the rotation
speed/tightening torque
♦
Press the torque preselection button
the required torque in stages.
♦
Press the ON/OFF switch
speed/tightening torque. Increasing the pres-
sure increases the speed/tightening torque.
■
The tightening torque depends on the selected
speed/torque preselection and impact duration.
NOTE
►
However, to tighten lug nuts, the smallest
torque setting must be selected to avoid over
tightening.
►
The integrated motor brake ensures rapid
stoppage.
CAUTION!
♦
The tightening torque actually attained must
always be checked with a torque wrench!
Changing the direction of rotation
♦
Change the direction of rotation by pressing
the rotation direction switch
or right.
Fitting the socket
♦
Push one of the supplied sockets
tool holder
.
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch off the appliance and remove
the battery before carrying out any
work on the appliance.
The appliance is maintenance-free.
■
The appliance must always be kept clean, dry
and free from oil or grease.
■
Never allow liquids to get into the appliance.
■
Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
to select
lightly for a low
towards the left
onto the
PASSK 20-Li C3
Werbung
