Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To that end, you must also
observe the safety instructions
of your plasma cutter.
„
Always wear a welding helmet
while welding and plasma
cutting. If it is not used, you
could sustain severe lesions to
the retina.
„
Always wear protective
clothing during welding and
plasma cutting operations.
„
Never use the welding shield
without the protective screen
because this could damage the
optical unit. There is a risk of
damage to the eyes!
„
Regularly replace the
protective screen to ensure
good visibility and fatigue-
proof work.
z Environment with
increased electrical
hazard
Environments with increased
electrical hazard may be
encountered, for example:
„
In workplaces where the space
for movement is restricted,
such that the operator is
working in a forced posture
(e.g.: kneeling, sitting, lying)
and is touching electrically
conductive parts;
12
GB
„
In workplaces which are
restricted completely or in
part in terms of electrical
conductivity and where there is
a high risk through avoidable
or accidental touching by the
operator;
„
In wet, humid or hot work-
places where the air humidity
or weld significantly reduces
the resistance of human skin
and the insulating proper-
ties or effect of protective
equipment.
Even a metal conductor or
scaffolding can create an
environment with increased
electrical hazard.
When using plasma cutters under
electrically dangerous conditions,
the output voltage of the plasma
cutter must be greater than
48 volt when idling (effective
value). The plasma cutter may not
be used in these cases due to the
output voltage.
z Plasma cutting in tight
spaces
When welding and plasma
cutting in tight spaces this may
pose a hazard through toxic
gases (risk of suffocation). In
tight spaces the device may only
Werbung
