Power Supply Unit Board And Relay Board - Honeywell 8010 Bedienungs- Und Installationsanleitung

Extinguishing Control Computer 8010 - Series 2

17.3 Power supply unit board and relay board

The combined power supply unit and relay board provides the entire voltage supply as well as the switching
outputs for control and status functions of the Extinguishing Control Computer. An increased current
requirement e.g. as a result of longer cable lengths, must be compensated for if necessary by an external
voltage supply via a separate power supply unit.
Constantly monitored conditions:
•
Mains failure
•
Battery charge
•
Battery charging, current limited
•
Earth fault identification (insulation)
REL 8 REL 7
NC NO C NC NO C
pot.- pot.-
free free
moni- moni-
tored tored
F5
F2
F3
emergency operation
F4
F1
NC NO C
REL 12
mains voltage relays
230V AC
Fig. 28: Power supply unit and relay board / position of the subassemblies
94
REL 6 REL 5 REL 4
NC NO C NC NO C NC NO C
pot.- pot.- pot.-
free free free
moni- moni- moni-
tored tored tored
F6 F9 F10
Power supply- and relay card
F10
F7
NC NO C GND 24V
REL 13 UBEXT
REL 3 REL 2
NC NO C NC NO C
pot.- pot.-
free free
moni- moni-
tored tored
F11 F12
battery 1
-
+
F14
to zone card
battery1
REL 1
NC NO C
pot.-
free
moni-
tored
F13 F16
F15
-
+
battery 2
Poti
battery2
FB 798352 / 11.07