12.9 Resetting the panel 8010
The Extinguishing Control Computer 8010 can be reset via the function key of the control panel. For operation,
the keypad must be enabled via the key-switch. To restart the system press the appropriate button. The internal
panel status and all visual displays will be resetted.
For deactivated zones or zones in >Test mode< the restart does not take affect.
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
Test operation
Un-
locked
Extra releasing 1
Outputs
Alarm
Fig. 15: Operating example – panel reset
12.10 Lamp test
The lamp test can be carried out via the keypad. For operation, the keypad must be enabled via the key-switch.
All visual displays of the control panel lights up and the control panel buzzer is activated until the key is
released.
Lamp test
Un-
locked
Fig. 16: Operating example – Lamp test
FB 798352 / 11.07
Panel reset
In operation
Extinguishing system
enabled
Extinguishing system
activated
1
Emergency release
Switching off
Test operation
Extra releasing 1
Fire/Switch off/Trouble
Outputs
Alarm
Extinguishing Control Computer 8010 - Series 2
Detector zone
2
3
4
5
6
7
8
9
10 11 12 13
Common trouble
Emergency
operation
Power trouble
Battery trouble
Ground fault
Trouble 1
Blocking
75