Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Loading objects
1.
Do not overload objects. When loading
objects, be sure to follow the instructions and
load limits in the manual.
2.
Since the larger the load, the more difficult it
is to operate the machine, keep the load within
the range that does not affect the operation.
Firmly secure the objects with ropes.
3.
4.
Load the objects within the carrier or bucket.
If the objects protrude from the carrier or bucket,
there is a risk of accidents due to the objects
falling or contact obstacles such as walls.
Be sure that loaded objects are below eye
5.
level. If the load is too high, it is dangerous
because the view is obscured. Also, there is a risk
of overturning and injury because the load is likely
to be unbalanced.
6.
Load the objects on the carrier or bucket
evenly. If the objects are loaded unevenly, there is
a risk of overturning and injury because the load is
likely to be unbalanced.
7.
Before loading the objects or operating the
machine, make sure that the handle of the
dump unit is fully pulled down and completely
locked.
8.
Be sure to load heavy objects first to keep
balance.
9.
Do not extend the front and side rails on steep
slopes. Extend the side rails when lightweight
objects are loaded.
10. When extending the front and side rails, do not
extend them over the extension limit. Be sure
to extend the side rails so that the right and
left sides are the same length, and load objects
evenly.
11.
Load and unload objects on flat ground. Never
load or unload objects on slope.
12. When lifting and tilting the carrier or bucket,
hold the handles and frame firmly, and work in
a stable posture.
Transportation of machine
1.
Use the ladder rails that are at least 4 times
as long as the height of the truck bed, with
fixtures suitable for the bed, with a non-slip
surface and sufficient width, and capable of
withstanding the weight of the machine and
operator. Read the instruction manual of the
ladder rails carefully before use.
Before loading the machine, unload all objects
2.
from the machine and remove mud and other
debris from the tires. Install the ladder rails on
a flat and stable surface.
Before loading or unloading the machine,
3.
make sure that there are no people around the
machine and the ladder rails. Load or unload
the machine at low speed, taking care to pre-
vent the machine from falling off the ladder
rails, and not to hit your head on the ceiling of
the truck. Use extreme caution when loading
or unloading the machine backward.
4.
When transporting the machine, lock the brake
lever, turn the power off, remove the batteries
and lock key, and fix the machine securely.
Maintenance and storage
Before storage or attempting to perform
1.
inspections or maintenance, always be sure
to stop the machine on flat ground and lock
the brake lever, and turn off the machine, and
remove the lock key and battery cartridges.
2.
Do not leave the machine unattended outdoors
in the rain.
3.
When storing the machine, avoid direct sun-
light and rain, and store it in a place where it
does not get hot or humid.
This machine is equipped with a hydraulic
4.
unit on the underside of the dump unit to auto-
matically tilt the dump unit. Do not modify the
hydraulic unit, or do not loosen the mounting
bolts of the unit or the adjustment screws of
the relief valve. It is very dangerous as it may
cause accidents or malfunctions.
Battery tool use and care
1.
Recharge only with the charger specified by
the manufacturer. A charger that is suitable for
one type of battery pack may create a risk of fire
when used with another battery pack.
Use power tools only with specifically desig-
2.
nated battery packs. Use of any other battery
packs may create a risk of injury and fire.
When battery pack is not in use, keep it away
3.
from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal
objects, that can make a connection from one
terminal to another. Shorting the battery termi-
nals together may cause burns or a fire.
4.
Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If con-
tact accidentally occurs, flush with water. If
liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause
irritation or burns.
5.
Do not use a battery pack or tool that is dam-
aged or modified. Damaged or modified batteries
may exhibit unpredictable behaviour resulting in
fire, explosion or risk of injury.
Do not expose a battery pack or tool to fire or
6.
excessive temperature. Exposure to fire or tem-
perature above 130 °C may cause explosion.
7.
Follow all charging instructions and do not
charge the battery pack or tool outside the
temperature range specified in the instruc-
tions. Charging improperly or at temperatures
outside the specified range may damage the
battery and increase the risk of fire.
Electrical and battery safety
1.
Do not dispose of the battery(ies) in a fire.
The cell may explode. Check with local codes for
possible special disposal instructions.
2.
Do not open or mutilate the battery(ies).
Released electrolyte is corrosive and may cause
damage to the eyes or skin. It may be toxic if
swallowed.
3.
Do not charge battery in rain, or in wet locations.
4.
Do not charge the battery outdoors.
Do not handle charger, including charger plug,
5.
and charger terminals with wet hands.
6.
Do not replace the battery in the rain.
19 ENGLISH
Werbung
