Cleanmaxx 12572 Bedienungsanleitung Seite 13

Cordless Handheld Vacuum Cleaner
CHARGING UP THE BATTERY
Please Note!
■
Make sure that the USB cable does not
present a trip hazard.
■
Do not charge up on a computer because
the computer might be damaged by the
high charging current.
■
Connect the USB mains adapter to a plug
socket that is properly installed. It must
be readily accessible so that the connec-
tion to the mains can quickly be isolated.
Charge up the battery fully before you first
use the device, or if the device has not been
used for a long time, so that it reaches full
capacity.
Otherwise the battery needs to be charged
if the device cannot be switched on.
1. Plug the barrel connector of the USB
cable (6) into the charging socket (4) and
connect the A connector to a suitable
USB mains adapter.
2. Connect the mains adapter to a plug
socket.
The charge control lamp in the A con-
nector lights up red and the battery is
charging.
When the charge control lamp lights up
green, the battery is fully charged.
USE
Please Note!
■
Make sure that there are no large, sharp
objects on the surface which is to be
cleaned.
■
Note the MAX marking on the collecting
container. If during use the marking is
reached, empty the collecting container.
Empty and clean the collecting container
after each use. The filters must also be
regularly cleaned in order to prevent
overloading of the motor.
12572_Inlay_DE-EN-FR-NL-ES-IT_A5_V1.indb 13 12572_Inlay_DE-EN-FR-NL-ES-IT_A5_V1.indb 13
■
Switch off the device after you finish
cleaning each surface to significantly
increase the operating time on each
battery charge. Charge up the battery
after use.
1. Plug the crevice nozzle (7) (see the
" Accessories" chapter) into the suction
opening (9).
2. To switch on the device, slide the
On / Off switch (1) to the I position.
The light (11) switches on and the
vacuuming process begins.
3. Guide the nozzle over the area to be
cleaned.
4. To switch off the device, slide the
On / Off switch to the 0 position.
5. To ensure optimum performance of the
device, empty and if necessary clean the
collecting container after every use (see
next chapter).
CLEANING AND STORAGE
Please Note!
■
Do not use any sharp or abrasive clean-
ing agents to clean the device. They may
damage the surfaces.
L
The filter may lose some of its
colour over time. This is normal and
does not have any adverse effect
on function.
1. Take off the accessory if it is located on
the device.
2. Press the release button (3) and take the
collecting container (8) off the motor
unit (5).
3. Remove the EPA11 filter (10).
4. Empty the collecting container over an
open dustbin or drain.
5. Tap out the EPA11 filter and clean it with
a soft brush if necessary. It can also be
rinsed out with clear water, but it must
be completely dry before it is assembled!
EN
13
08.05.2023 10:52:17 08.05.2023 10:52:17