Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Notes:
® Before
installation
check
the
radio operation
with antenna and speakers.
Unit in-dash Installation
installation Opening
in-dash installation can be done if the car's dash-
board has an opening for this unit as shown in Fig.
2. The car's dashboard should have a thickness of
4.5mm - 6mm
in order to make the installation of
the unit.
To Remove the Unit from the
Quick Release Bracket
The unit is inserted and locked in the quick release
bracket at the factory. The unit can be released by
following the steps below:
2. Remove the unit from the bracket by pulling the
handle firmly. (Fig. 3, @)
wi46
Mounting Spring
| CQ-RD55LEN
——
Installation Procedures
1. Insert the quick release bracket into the car's
dashboard and bend the mounting springs corre-
spondingly by means of a screwdriver, as shown
in Fig. 3.
to the car's dashboard, read "To Secure the Rear
of the Quick
Release
Bracket"
which
is ex-
plained in the next page and check whether the
rear of the unit is properly secured to the fire wall
of car.
Also check the electrical connections by refer-
ring to this operating
instructions.
Mount the
quick release bracket to the car's dashboard as
shown in Fig. 3.
4. After
installation
reconnect
the negative
|—)
battery terminal.
Installation Parts List
Description
Quick Release Bracket
|
Rear Support Strap
|
Hex. Bolt (6mm
x 25mm)
Hex. Nut (6mm¢)
Spring Washer (Smm¢)
|
Plain Washer (5mm¢)
Toothed Lock Washer (5mm4¢)
Mounting Bolt (5mm)
OYQOOQOSOOONO}|:
—~—=—nN
nn
— = a
Quick Release Bracket
Werbung
