Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CQ-RD55LEN
|
7
DISASSEMBLY INSTRUCTIONS / ANWEISUNGEN
FUR DES AUSBAU
Mi DECK ASS'Y REMOVAL
To remove the Upper Cover, Under and Escutcheon Ass'y, refer to EXPLODED VIEW(UNIT)on page 48.
(1) Disconnect the 7P and 5P connectors before disconnecting the deck.
(2) When the deck is mounted back in place, reconnect them after tightening the Screws.
(3) Tighten the screws in the order of ©, @, @,and ©.
@
8
MB BATTERY (BT601) REPLACEMENT
(1) Remove the top cover, bottom cover, and deck assembly.
(2) Use the connector
CN1
(YEAJ02607)
connect
14.4V to
_ Red-lead and Black-lead to ground, and set power switch
is ON.
ia HEAD
REPLACEMENT
(3) Keep SW601
to the arrow
( direction.
4) Unsolder the battery terminal
h
©
Remove
the two screws
(A).
(4)
Unsolder
the
battery nin
s on the pattern end and
replace the battery with a new one.
e Remove the one screw (B) of flexible P. C. B.
iS) KeapSwWe0t tothe arrow
accion
e Remove the tape head.
,
(To assemble, proceed in reverse
order of disassembly.)
Tape Head
Flexible P. C. B
e@ NOTES:
» After the battery replacement, install the deck assembly
and check that all the functions of the set operate normally.
Tone batterie (BAT 601)
iAtss
Werbung
