Werbung
Verfügbare Sprachen
Verfügbare Sprachen
RECORDING
_____ PREPARATION
_
@ Press the MAINS POWER switch on the rear panel to ON.
Switch 20:
Set to OFF if you are going to record in VHS on
@ Press the OPERATE switch on the front panel to ON.
an S-VHS cassette.
©
Insert a video cassette tape in the cassette loading slot.
Switch 40:
Set to OFF if you wish to cancel Hi-Fi audio
@ Set the AUDIO MONITOR SELECT switches as required.
recording.
@ Check the Memory Switch settings. (See page 5.)
Switch 41:
Dolby ON or OFF.
Switch 00:
ON
to apply framing
servo
to recordings.
Switch 43:
If time code recording is required, set to ON.
However, we recommend you set it to OFF
when recording from low-quality signals, such
as
multi-generation
copies or non-frame-
recorded tapes.
td
J
eo
O60!
i bbe,
@
tan
i CE
@
4@
d Ef
@ lh4
}
e@ Set the METER SELECT switch to AUD-2/R.
RIGHT/LEFT) until the meters deflect to "0" with the loudest
© Adjust the AUDIO REC LEVEL controls (Hi-Fi and NORMAL,
signal. This is the standard audio recording level setting.
@ Press the REC and PLAY buttons simultaneously to start
© @ Press the STOP button to stop recording.
recording. Both the REC and PLAY LEDs will light.
|
RECORD-PAUSE & ASSEMBLE EDITING
= =
You can stop recording temporarily and restart it without
@ To restart recording, press the PLAY button. The recorder
causing any detectable distortion in the picture.
will play back the tape for 3.0 seconds,
then switch
@
Press
the
PAUSE/STILL
button
during
recording.
automatically to the Record mode at the point where the
Recording will stop but the REC indicator will remain lit.
PAUSE/STILL button was originally pressed.
@ The tape automatically rewinds about 3.0 seconds of
@ During the 3.0-second playback prior to re-engagement
program time and stops in the Record-Pause mode.
Both
of the Record mode, the picture seen on the screen is
the REC and PAUSE/STILL LEDs will be lit.
not the playback picture, but the input signal to be
recorded.
e lf the Record-Pause
mode
continues
for about
5
minutes, 20 seconds, the tape tension loosens and the
drum stops. To restart recording from this status, simply
press the PLAY button.
-12—
Werbung
