Stihl RME 339 Gebrauchsanleitung Seite 39

6. Standard equipment
Item Designation
A Basic unit
B Upper part of grass catcher
box
C Lower part of grass catcher
box
D Pin
Instruction manual
RME 339 C:
E Sleeve
F Bolt
G Washer
H Nut
RME 339:
I Flat head bolt
J Cable guide
K Rotary handle
L Cable clip
The standard equipment may vary
depending on the country where
sold and version type.
7. Preparing the machine for
operation
7.1 General
Risk of injury!
Observe the safety instructions in
the section "For your safety" (
0478 121 9919 C - EN
● Place the machine on level and firm
ground when performing all the
operations described.
2 7.2 Installing mono handlebar
(RME 339 C)
Qty.
1 ● 1 Insert sleeve (E) in the bore
on handlebar (1).
1
● 2 Fit two washers (G) with the convex
1
side facing inwards onto the sleeve.
● 3 Hold sleeve (E) and washers (G)
2
and insert together with handlebar (1)
1
into console (2).
● 4 Insert nut (H) into the console as
shown.
1
● 5 Insert bolt (F) from outside inwards
1
through the bores in handlebar (1) and
2
in console (2). Tighten bolt (F).
1
Tightening torque:
18 - 22 Nm
Installing electric cable:
2
● Insert the electric cable (3) in the strain
1
relief moulding and press into the
2
holders on the console and the
1
handlebar (4, 5) as shown. Insert the
cable into cable clip (6), close tab and
allow it to engage.
7.3 Installing dual handlebar
(RME 339)
Installing upper handlebar:
● Insert flat head bolt (I) through cable
guide (J) and attach electric cable (1).
4.).
● Fit dual handlebar (2) onto both lower
handlebar sections (3). Insert flat head
bolts (I) – on right with cable guide (J),
on left without – through bores from
inside outwards and tighten with rotary
handles (K).
Installing cable clip:
3
Danger of electric shock!
In order to prevent damage to the
insulating layer on the handlebar,
only press on the cable clips by
hand. Do not use any tools (e.g.
hammer or screwdriver).
● Install cable clip (L) on the upper
handlebar. Insert electric cable (1) as
shown. Close tab (4) and allow it to
engage.
Distance between the cable clip and
switch:
25 - 27 cm
7.4 Assembling the grass
catcher box
● Fit the upper part of the grass
catcher box (B) onto the lower part of
the grass catcher box (C). Ensure
correct location in the guides.
● Push pin (D) through the bores
provided from inside.
● Allow the upper part of the grass
catcher box (B) to engage in the lower
4
part of the grass catcher box using
slight pressure.
● Attach the grass catcher box (
5
8.4).
37