Inhaltsverzeichnis
Werbung
2. INSTRUCTIONS FOR USE
2.1) Setting
Select the appropriate die set. Two styles of die set are available:
– Die Sets for cutting contact wire: the die profile matches the profile of the contact wire.
– Die Sets for cutting conductor: the die profile matches the profile of the conductor.
2.2) Positioning
– Insert the die set into the head (see § 2.6).
– Position the conductor inside the die set so that the blade (39) lines up with the desired
cutting point.
– Close the die set (see fig. 2) by moving the locking handle (40) towards the tool body,
until automatically 'locked' in position and securely clamping the wire/conductor (see
fig. 3).
– Press operating button (3) to activate the motor-pump group for the advancement of
the blade (39) to the conductor (see fig. 4).
Before proceeding with the cutting operation, ensure that the locking pin (29) is
fully inserted into the head and the locking handle (40) is securely locked in position.
Check that the cutting edge of the blade coincides with the desired cutting point,
otherwise re-open dies following instructions as per § 2.5 and reposition the
wire / conductor.
2.3) Cutting
Continue pressing operating button (3): the blade (39) progressively advances until the
conductor is completely cut in a clean and precise manner, without deforming the conductor
itself. To halt the advancement, release operating button (3) and the motor will cut out.
The motor will continue to operate after the maximum pressure relief valve has activated.
No further cutting force is applied, the oil is bypassed and returned to the reservoir.
D
o not attempt to cut steel roDs with this tool
2.4) Head rotation
For ease of operation, the tool head can rotate through 180°, allowing the operator to work
in the most comfortable position.
Warning: Do not attempt to turn the head if the hydraulic circuit is pressurised.
2.5) Release of dies
– Press the pressure release button (8) for rapid retraction of the ram (22).
– By releasing the locking handle (40) the dies open and release the wire/conductor.
2.6) Inserting the die set
– Remove the locking pin (29) and insert the die set into the top of the tool and position
the 'locator' (A) in the guide at the bottom of the head. Ensure that the recess (B) on
the front of the die set faces the blade (39).
– Fully insert the locking pin (29) into the head.
The die set is polarised and can only be installed one way to ensure the correct
insertion of the locking pin (29).
– To remove the die set from the head: open the locking lever (40), completely remove
the locking pin (29) and slide the die set out of the tool.
31
4
(Ref. to Figs. 1, 2, 3 and 4)
(Ref. to Figs. 1 and 5)
ENGLISH
.
Werbung
Inhaltsverzeichnis
