Assembling The Floor Fixture - Rehau RELAZZO SCREEN Montageanleitung

2
No spacers are required at the bottom for this assembly.
Screw the two cross beams and the support beam together to form a
„C". Ensure that the lower cross beam (with RELAZZO logo and water
drainage holes) is fitted in such a way that the support beam always
protrudes by 10 cm.
Push on the end cap on the left before screwing it down.
3
4
22
Individually insert the WPC profiles with the pre-assembled lateral
spacers.
5
Push on the right support beam on the right and attach the missing
end cap.
Screw down this support beam.
6
If necessary, push the WPC profiles together from left to right
individually so that the support beam is easier to screw down.
9 2

Assembling the floor fixture

It is essential to fix the base plates to a solid and stable concrete
foundation. Composite stones, stone slabs or decking boards are
unsuitable as they do not provide the required structural stability. If not
fixed properly they may cause personal injury or damage to property.
The stability should be tested after being subjected to extreme loads
and at least once per year.