Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
After you connected the spot to the mains, the LED KLS-40 starts running.
The display lights up and you can choose the desired mode via the buttons MENU, ENTER, UP and DOWN.
Stand-alone mode
In the stand-alone mode, the LED KLS-40 can be used without controller.
Disconnect the LED KLS-40 from the controller. Please refer to the instructions under chapter Control Board.
Master/Slave-operation
The master/slave-operation enables, that several devices can be synchronized and controlled by one
master-device.
On the rear panel of the LED KLS-40 you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which
can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT jack with the DMX IN plug of the next device.
Set the desired master-mode „AUto" or „SOUd" - for the master-device, as described in chapter Control
Board. Set the DMX address 1 for all slave-devices.
DMX-Mode
The device has seven different DMX channel modes. The Control Board allows you, as described below, to
assign the DMX channel mode.
Addressing
Press the MENU button until the display shows DMX Address. You can now set the desired address via the
UP or DOWN buttons. Press ENTER to confirm. The Control Board allows you to assign the DMX fixture
address, which is defined as the first channel from which the LED KLS-40 will respond to the controller.
If you set, for example in the 24 channel mode, the address to channel 25, the device will use the channel 25
to 48 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED KLS-40 correctly
and independently from any other fixture on the DMX-chain.
If several LED KLS-40 are addressed similarly, they will work synchronically.
Controlling:
After having addressed the LED KLS-40, you may now start operating it via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, a dot in the display will flash. If there is no data received at the DMX-input, the dot in the display
will not flash.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective,
- the cable or connector is defective or the signal wires are not properly connected with the input connector.
30/40
00091417.DOCX, Version 1.0
Werbung
Inhaltsverzeichnis
