Herunterladen Inhalt Inhalt Diese Seite drucken

Danger To Life; Mounting On A Speaker Systems; Dmx-512 Connection / Connection Between Fixtures - EuroLite LED KLS-40 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

carbines must be sufficiently dimensioned and used correctly in accordance with the latest industrial safety
regulations (e. g. BGV C1, BGI 810-3).
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already held the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

Mounting on a speaker systems:

For mobile use, the device may be placed on a speaker system.
1
On the speaker system, first loosen the fixation screws of the legs. Pull out the legs until the cross struts
stand at a 90° angle to the legs. Tighten the fixation screws of the legs.
2
Loosen the knurled head screws on the mounting bracket of the device and install the fixture on the tube
via the holder. Tighten the fixation screw.
3
Caution! The load has to be installed in a balanced way. The carrying capacity of the speaker system
must never be exceeded. The speaker system must be set up in a stable way. Make sure all fixation
screws fit tight.

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Only use a DMX-cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture
or one fixture with another.

DANGER TO LIFE!

the devices will not work at all, or will not work properly.
28/40
00091417.DOCX, Version 1.0

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis