Technical Specifications - cecotec CONGA WINDROID 880 SprayWater Bedienungsanleitung

ENGLISH
When activating, it emits a failure signal (red
sensor and sound signal).
Possible reasons for the robot to slip and not
climb.
The robot does not work properly. Possible
causes:
The robot does not spray water or glass
cleaner.

6. TECHNICAL SPECIFICATIONS

Product: Conga WinDroid 880 SprayWater Smart Connected
Product reference: 05050
90 W, 100-240 V~, 50/60 HZ
Li-ion battery:
14,8 V DC
600 mAh
Charger:
Input: 100-240 V~, 50/ 60 Hz 2.0 A
Output: 24 V DC 3, 75 A.
Charging time: approximately 2 hours.
Autonomy up to 30 minutes (for mains failure)
Operating temperature: 0 ºC~75 ºC
Remote control operation with 2 AAA batteries.
Made in China | Designed in Spain
54
The robot tests its operationg when activated.
If you notice that the friction is too long or too
short, it fails. Possible reasons may be:
The cloth is too dirty.
The glass is too clean and the surface slips.
If the glass is wet, the surface slips.
There are stickers on the glass surface.
Check the mains connection.
Humidity, stickers...
The cloth is too wet.
The window is too clean.
When humidity is very low (rooms with air
conditioning).
It does not respect the safety distance with
the frame.
The cloth is too dirty.
Different types of surfaces in the same
cleaning area (sand area, stickers...)
The screw does not make a good connection.
Check the spray mode is activated.
Clean the nozzle with a soft, clean cloth.
Check the water tank is full.