Parkside PEXS 270 C3 Originalbetriebsanleitung Seite 9

Attachment
You can attach the sanding sheet 4 to the
♦
sanding pad 3 using the Velcro.
♦ Ensure that the extraction holes on the sanding
sheet 4 match up with those on the sanding
pad 3. Use the sanding sheet alignment
tool 9 as shown in fig. A on the fold-out page.
Removal
♦ Simply pull the sanding sheet 4 off the
sanding pad 3.
Dust/chip extraction
■ Please refer to the section entitled "Safety
information".
Self-extraction with dust collector
Connection
♦ Push the dust collector 2 onto the appliance.
Turn the dust collector 2 towards the
bol to lock it.
Removal
♦ Turn the dust collector 2 towards the
Pull the dust collector 2 off the appliance (see
detailed illustration on fold-out page).
NOTE
► To ensure optimum extraction, empty the dust
collector 2 regularly.
♦ To do this, remove the dust collector 2 from the
appliance as described above. To do this, open
the dust collector 2 by pressing on the release
button 8 and pulling off the rear part (see
detailed illustration on fold-out page). Now
remove the dust bag. Clean the dust bag
thoroughly by tapping it out.
External extraction
Connecting
♦ To remove dust using a vacuum cleaner, push
the suction hose of a suitable dust extraction
device (e.g. a workshop vacuum cleaner) onto
the exhaust nozzle 6.
│ GB │ IE
■ 6
NOTE
► If necessary, use the adapter 7 by pushing it
into the exhaust nozzle 6.
Removal
♦ Pull the hose of the vacuum cleaner off the
exhaust nozzle 6 or the adapter 7.
Use
Switching on and off
NOTE
► Always switch on the random orbital sander
before making contact with the material, then
apply it to the workpiece.
Switching on
♦ To switch the tool on, slide the ON/OFF
switch 1 forwards.
sym-
Switching off
♦ Slide the ON/OFF switch 1 backwards to
switch the tool off.
symbol.
Speed preselection
♦ Select the required speed with the speed
control 5.
Level 1: low speed
Level 6: high speed
Working procedures
■ Wait until the power tool has come to a standstill
before putting it down.
Sanding surfaces
♦ Turn on the power tool and ensure that the
whole grinding surface is in contact with the
material being worked. Move it with moderate
pressure over the workpiece.
NOTE
► The removal rate and the sanding pattern are
mainly determined by the choice of sanding
sheet and the contact pressure. Only flawless
sanding sheets achieve good sanding results.
PEXS 270 C3