Herunterladen Diese Seite drucken

Electrolux KOEBH09H Benutzerinformation Seite 40

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• Clean the interior of the appliance after
each use. Fat accumulation or other
residue may cause fire.
• Moisture can condense in the appliance or
on the door glass panels. To decrease the
condensation, let the appliance work for
10 minutes before cooking. Do not store
food in the appliance for longer than 20
minutes. Dry the interior of the appliance
only with a microfibre cloth after each use.
Accessories
• Clean all accessories after each use and
let them dry. Use only a microfibre cloth
with warm water and a mild detergent. Do
not clean the accessories in a dishwasher.
• Do not clean the non-stick accessories
using abrasive cleaner or sharp-edged
objects.
12.2 Removing the shelf supports
Remove the shelf supports to clean the
appliance.
1. Turn off the appliance and wait until it is
cold.
2. Pull the front of the shelf support away
from the side wall.
3. Pull the rear end of the shelf support
away from the side wall and remove it.
1
2
Install the shelf supports in the opposite
sequence.
12.3 Aqua Clean
This cleaning procedure uses humidity to
remove remaining fat and food particles from
the appliance.
1. Pour water into the cavity embossment:
300 ml.
2. Set the function
3. Set the temperature to 90 °C.
Duration: 30 min.
4. Turn off the appliance.
40
ENGLISH
.
5. Wait until the appliance is cold. Dry the
oven interior with a soft cloth.
12.4 Removing and installing door
The oven door has three glass panels. You
can remove the oven door and the internal
glass panels to clean them. Read the whole
"Removing and installing door" instruction
before you remove the glass panels.
CAUTION!
Do not use the appliance without the
glass panels.
1. Open the door fully and hold both hinges.
2. Lift and pull the latches until they click.
3. Close the oven door halfway to the first
opening position. Then lift and pull to
remove the door from its seat.
4. Put the door on a soft cloth on a stable
surface.
5. Hold the door trim
the door at the two sides and push
inwards to release the clip seal.
on the top edge of

Werbung

loading