Endress+Hauser Proline 300 Bedienungsanleitung Seite 28

EA01278D
9.4 Additional information on reassembling the transmitter hous-
ing, compact version
1 →
‣
 Insert the new S-DAT into the
ISEM before reassembling.
For detailed information on the electrical connection, see the "Electrical connection"
section of the Operating Instructions for the device.
For detailed information on commissioning, see the "Commissioning" section of the
Operating Instructions for the device.
10 Promag 5D4C, 5L4C, 5W4C transmitter, remote
version
10.1 Replacing the connection board
Proceed as described in Section 9.2, →  25, graphics 1 - 8 and in the graphics below.
1 →
28
2
‣
 Make sure that the plug of the ISEM is plugged in correctly.
2
Endress+Hauser